|
|
Post by Haines Garage on Sept 14, 2014 17:36:42 GMT -5
I want to take this giant roll out of the side of my tub. Any thoughts ?   |
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Sept 14, 2014 17:56:22 GMT -5
Wow. Flat metal like that with a big stretch is tough. Maybe replace it all with new flat metal. Once you tie off (weld) all the sides, you have to pull lots of shrinks and then spend eons of time until finally skim coating the whole thing with bondo. I hate those inner wheel wells. YUK! Oil
|
|
|
|
Post by Haines Garage on Sept 14, 2014 18:52:10 GMT -5
I was afraid someone would say that.
Perhaps I will try A BFH first .....
I am assuming you all realize what this thread is for.
Should be a very interesting one .
|
|
|
|
Post by athawk11 on Sept 14, 2014 22:06:10 GMT -5
If you are willing to pull the whole wheel well off, you can put that portion flat on a concrete floor and hammer away at it, then shrink, then hammer some more. This made my wheel well repairs fairly easy.  |
|
|
|
Post by Haines Garage on Sept 15, 2014 7:07:44 GMT -5
Tim,
Which Jeep are those from?
|
|
|
|
Post by athawk11 on Sept 15, 2014 21:36:45 GMT -5
HG, These are the wheel houses used on Whitey. One is a 2A. One is a 3A. I modified the 2A to match the 3A...    |
|
|
|
Post by zooke581 on Sept 15, 2014 21:44:45 GMT -5
Anything is possible. It's just what you are willing to do. Me, I would put in a new piece of sheet steel. Not good at heating and shrinking.
|
|
|
|
Post by Haines Garage on Sept 16, 2014 8:41:07 GMT -5
Thanks for the pics Sir Hawk !
That is some awesome stuff there!
|
|
