Deleted
Deleted Member
Posts: 0
|
Post by Deleted on May 3, 2016 17:50:15 GMT -5
Ok guys, I have one for you. On a L4 134 gear drive flathead engine referencing the crank and timing gear cover. On the outside of the cover where the crankshaft fits through the seal, what is that round thing that looks like a donut on the outside. It would be where the back side of the crankshaft pulley would rest against it. What I do know is that the chain drive engine doesn't have this. Just thought I would throw that in. Any help would be great.
|
|
|
|
Post by Haines Garage on May 3, 2016 19:26:57 GMT -5
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on May 3, 2016 21:51:56 GMT -5
So which part is the donut??!  |
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on May 3, 2016 22:11:25 GMT -5
the round donut looking thing around the crankshaft hole on the outside cover.
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on May 3, 2016 22:15:59 GMT -5
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on May 4, 2016 5:46:03 GMT -5
 I had that thought once before to. I don't know though. |
|
|
|
Post by Haines Garage on May 4, 2016 10:51:19 GMT -5
|
|
|
|
Post by athawk11 on May 4, 2016 11:14:35 GMT -5
Can't say for certain. Spacer...seal retainer/protector...stiffener...pulley stabilizer. It doesn't have an individual part number.
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on May 4, 2016 20:33:44 GMT -5
Homer Simpson was exactly what came to my mind, too. I've had donuts on my brain for 48 hours now. I would love to have one of those white powdered bastages with vanilla icing on the inside...or even just a simple chocolate glazed donut would be sweet. Haines, forget Chinese. Let's gorge in donuts and then polish it off with a Starbucks latte.
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on May 5, 2016 5:01:55 GMT -5
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on May 5, 2016 6:55:24 GMT -5
I'm going to say additional dust/grass shield to help keep the seal area protected.
|
|
