Post by Deleted on Apr 1, 2016 17:35:09 GMT -5
This is the hub puller that I made from a couple pieces of angle iron and a short piece of channel. The weld is kinda farmer, but hasn't broke yet. Not hard to make, maybe half hour, and will outlast me!!
The only thing I would do different is use a fine thread bolt as it will give you almost twice as much pulling power. But I had no problem, just tighten it up real good and pop it with a BFH. And be sure to have the axle nut on so the whole thing does not fly across the room!!
Chuck
