|
|
Post by Haines Garage on Mar 22, 2013 17:03:07 GMT -5
After a ton of research, and trying to solve the leaky transmission problems. Some other members, and myself had some reproductions made of the elusive Transmission to Bell Housing Gasket. I will post other photos of its installation. Attachments:
|
|
|
|
Post by Haines Garage on Mar 22, 2013 17:30:49 GMT -5
With nose piece installed, Indian Head shellac as sealant Torque bolts to spec. Attachments:
|
|
|
|
Post by Haines Garage on Mar 22, 2013 17:32:31 GMT -5
Indian Head Shellac applied to gasket, and bell Housing, installed torque to spec. Attachments:
|
|
|
|
Post by Haines Garage on Mar 22, 2013 17:33:43 GMT -5
These will be for Sale here! Check them out! USA Made!
|
|
|
|
Post by Haines Garage on Mar 22, 2013 17:34:55 GMT -5
Leak points covered Attachments:
|
|
|
|
Post by Haines Garage on Mar 22, 2013 17:35:55 GMT -5
Leak point covered Attachments:
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Mar 24, 2013 11:19:12 GMT -5
I would like to get my newly rebuilt front end T 90 dry and tidy but until now I only know I have not managed with the gaskets I got for the front to get it oil tight, so the left part of the armor plate is wet after a drive.
I am not ready yet to pull the t 90 to get it fixed.
Anyone tried to solve the problem by getting a 1/8 inch space between bellhousing and the
T 90 and then inject a putty/ or sealant in between to reach the spots you show with a knife on the pics. I understand this does not sound very clever but it would be no harm done if it would not work.
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Mar 24, 2013 17:10:14 GMT -5
Sten, If you did not get yor putty or sealer evenly spread over the entire face of the transmission, it could cause misalignment of the bellhousing/transmission, resulting in wear in the clutch pilot bearing, the transmission main drive gear bearing, the transmission mainshaft pilot bearing, and the 3rd gear synchronizer, also maybe wear to the clutch disc and input gear splines. Could cause shifting problems too. BW
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Mar 27, 2013 13:53:33 GMT -5
BW, good point!
|
|
|
|
Post by Haines Garage on Mar 28, 2013 20:00:27 GMT -5
Sten,
Should you like a set of Gaskets...I would love to send them to you. $15.00 plus shipping to Sweden. You will like them, I promise.
|
|
|
|
Post by Haines Garage on Jun 8, 2013 21:46:38 GMT -5
This seems to continue to be a topic of Great debate.....Answer is plain and clear...YES THERE WAS A BELLHOUSING/TRANSMISSON GASKET IN CJ2As and 3As
|
|
